Home / Blog

Before adding window shade, record where the sun reaches

· 7 min read

Before choosing an awning, shutter or new overhang, record which part of the window receives direct sun and when. Include the hours you use the room, the position of any existing shading and the daylight you want to keep. This gives a designer a more useful starting point than a photograph of a shaded terrace taken at noon.

Start with one troublesome window rather than a shopping list for the whole house. The aim is to describe the gap in the shade, not to calculate an overhang or diagnose every source of heat. The blank record below is an original discussion aid, not a building assessment or a tested monitoring method.

Watch the glass, not just the floor

A roof may shade the paving outside while leaving part of the window exposed. Look at the top, bottom and sides of the glass separately. From a safe position, note whether it is fully shaded, partly shaded or receiving direct sun. If a tree supplies the shade, record that too; do not attribute every shadow to the roof above.

Then look inside. Does sunlight reach a desk, a chair, the floor or an internal wall? Note the location without treating the size of the bright patch as a heat measurement. A glare problem at a desk and a room that stays warm after sunset are different complaints, even if both deserve attention.

The Building America Solution Center's shading guide distinguishes direct sunlight from diffuse daylight and explains that shading performance changes with the sun's daily and seasonal position. A sunless moment does not establish that the window is protected throughout the day.

Use a photograph from roughly the same position for each observation if that is convenient. Keep the time and date with it. Avoid including people or neighbouring private interiors, and do not climb out of a window or onto a roof to get the picture.

Give each window an identity

Label the opening on a simple room sketch: for example, "kitchen, door to courtyard" or "bedroom, window beside wardrobe". If one room has windows on different walls, give each its own record. Otherwise, a note saying "the blind was closed" can become ambiguous later.

Add the direction the window faces if you know it, and record how you established it. If you are unsure, write "orientation to confirm". Supply the location of the house so the designer can check the direction and local sun path rather than work from a guessed compass label.

The US shading guide describes low morning sun on east-facing windows and low afternoon sun on west-facing ones. It also explains why an overhead shade can leave those lower-angle rays unblocked. Its south-facing examples and sizing guidance are location-dependent, not dimensions to copy onto another house. Read the orientation and overhang sections as explanations of the geometry, not as a universal specification.

For your record, the useful detail is where the shade fails: along the bottom, at one side, across the whole opening or only at a particular hour.

Observe the hours that matter to the household

Choose observation times around actual use. A breakfast table needs a different description from a bedroom used after work. Include an earlier check where practical, so the record does not begin only when someone notices discomfort.

Write down what you saw at each visit. If you checked at noon and again in late afternoon, leave the intervening period unknown. "Sun first observed at the second check" is more accurate than claiming that it arrived at that exact time.

Keep normal use visible in the notes:

Do not switch off cooling or remove existing protection to make this exercise more revealing. Record ordinary, comfortable use. If you already have temperature readings, keep their times and instrument positions, but leave unmeasured values blank. This record cannot isolate the effect of shading from all the other conditions in the room.

Keep summer evidence separate from today's weather

An autumn afternoon is not a reconstruction of a July afternoon. If you are planning after the hot season, use dated summer photographs or notes where you have them. Label remembered impressions as memories, not measured observations. "We remember glare during dinner" can prompt a useful question without pretending to establish a time or duration.

Ask the designer to assess the missing season. The PNNL overhang guidance cautions against considering only the summer and winter solstices: the hours and months between them also matter. It identifies latitude, orientation, overhang width and the height above the window as relevant inputs, alongside depth and climate.

That is why one photograph or a generic depth-to-window ratio is not enough to specify a new canopy. Where winter sunshine is welcome, say so in the brief. Where it is unwanted, record that instead. Do not assume that every household wants the same seasonal balance.

Describe what a closed shade would interrupt

Shading has to work with the room, not just cover its glass. Before comparing products, write down which functions you need to retain. Perhaps the window is the only useful view from a desk. Perhaps a door opens onto a small courtyard, or the handle becomes awkward to reach behind the existing blind.

The Building America guide to window attachments treats glare, privacy, daylight and outside views as distinct selection goals. It also distinguishes fixed shading from attachments that occupants can adjust. Those distinctions are more useful at this stage than declaring one product type the winner.

List the conflicts in plain language. "We need shade while the glazed door is in use" is a design requirement. "We can close the shutters before leaving but cannot adjust them at lunchtime" is an operating constraint. An adjustable system should be assessed against that routine, not against an imaginary person who is always home.

Ask the designer or installer how the proposal preserves necessary ventilation, window operation and any required escape route. For an exterior installation, ask who will assess the support, exposure to weather, maintenance access and any permissions. These are matters to resolve before work, not fixing instructions supplied by this article.

Copy this window record

Use one copy per opening and add a dated observation entry each time. These fields are deliberately unfilled. They are not an official survey form or evidence that a particular product is suitable.

Opening and purpose

Dated observation

Questions for the design meeting

Bring this record with any reliable drawings. Ask the designer to show how the proposed shade covers the particular opening at the troublesome times, and to explain the seasonal trade-offs. Agree how the result will be checked after installation. The useful outcome is a proposal tied to a window and a household routine, rather than a promise that a deeper roof or darker blind will solve the whole room.

Sources

← All posts